Reed canary grass (Phalaris arundinacea)

reed canary grass

                         Reed canary grass (Phalaris arundinacea)

                  

Sowed in late Summer 2014 and doing nicely.

Surface sow onto moist compost/vermiculite/perlite (1:1:1), mist and cover with cling film.Took about 2 weeks to germinate and has been going crazy ever since.Dies down over winter and will happily survive the harshest of UK conditions outside.When its dies down over winter, I usually flame it to burn the stubble. Seems to like this, as it shows.If we put this into the ground it would reach 2-3 meters in height, but as we ship these all over the world we keep them small, so you can plant them.

 Leaves of Reed canary grass contain DMT, 5 MeO DMT and related compounds. Levels of beta carbolines and hordenine have also been reported.

They are invasive, so dont plant them anywhere that this may cause problems.

Sea bean (entada rheedii) germination TEK

Sea bean (entada rheedii) germination TEK

 Sea beans have a hard shell to allow them to survive being washed up on beaches where they can germinate. Germinating them can be difficult, but hopefully, using this TEK you might enjoy the same success as we have.

 Drill into the bean at the point where it was attached to the pod (its belly button), using a flat tipped 5-6mm drill and a hand brace & bit. If you use a mechanical drill you may cause damage to the germ in the shell. We held the seeds in a vice, but took care not to tighten it too much as they can crack. Only drill as far in, until you can see the white pulp in the seed. (maybe 3-4mm deep, depending on the size of the seed).

 Take an OLD flask and fill it with boiling water. (it will have to be smashed to get the swollen beans out again, so dont bother using a new one!)

 Make sure that the beans fit through the neck of the flask! If they dont, you will need a bigger flask. (We use a flask because it keeps the water hotter overnight.)

 Our beans nearly got stuck on the way in! Once they have soaked for upto 12 hours in the flask, you will have to smash the flask to remove them, as they will have swelled up considerably. Do this carefully as a vacuum flask will often explode sneding shards of glass everywhere (as we found to our dismay!)

 The next step is to try to recreate the beach they will germinate upon. We used perlite, but washed sand will work fine. Make sure it is nice and wet and warm and mist regularly. Cover with Cling-film (Saran-wrap) to keep the humidity high. Make sure they are in a bright place, as they need the light to help them pop!

After about 20-30 days they will have cracked open, like a clam shell, from the hole you drilled. The root will start to find its way down and the shoot will head toward the light. Put them back in their 'faux beach' pot for another few weeks and then pot in a mix of compost/perlite/vermiculite (1:1:0.5). They need reasonable humidity, lots of light and plenty of fresh air as they can be susceptable to rot.

My salvia arrived in the post. What do I do now?

This is a question we get asked quite a bit.

When your salvia arrives it will be in a plant-pak to protect it from the post and to keep it humid.

Unpack it gentely and pot it into a mix of compost, perlite and vermiculite (1:1:1) I have used a small pot here just for demonstration purposes, but as long as the pot you use fits inside the bottle, all will be well.

Snip the bottom off a clear plastic bottle, place the pot on a tray or saucer and gentely lower the bottle over the salvia. mind those rough bottle edges on the leaves now!

Mist the plant and leave at room temperature in the light. Not direct sun as this will cause the bottle over-heat and kill your new Salvia Divinorum plant.



 Every now and then (I usually do it when I walk past the bottle) lift the bottle for a minute or two to let some fresh air in, otherwise the air will stagnate and mildew will start.

After a couple of days remove the lid. This will lower the humidity and help to acclimatize your plant to your home. Still remembering to lift the bottle as you think about it. A couple of times a day should be fine for now.

After about a week of no lid and lifting the bottle, remove the bottle completely and mist.

If your salvia starts to wilt within an hour or so, put the bottle back on and carry on with the acclimatizing process for a few more days. Soon she will be happy to live out of the bottle in the lower humidity of your home.



Salvia divinorum likes damp (but not soggy) roots and an occasional misting. Direct sun will cause her to wilt and frost will kill her. During the winter, in the UK especially, she will slow her growth and some of the leaves will develop brown tips. This is perfectly normal and she will pick up again in spring.

Germinating Baby Hawaiian Woodrose seeds.

Nice simple TEK this one!

I have been asked a few times this week how to germinate these little blighters. So i thought this would be the best way to explain,

 As you can see, Hawaiian Baby Woodrose seeds are not tiny, but small enough to be a bit fiddly, especially if you have big hands!

The seed has a round and a pointed end.

  

Snip the point off the pointed end to help the seed germ break free, as the shell is quite a tough one!

Then plant in damp vermiculite, about 1/2 inch deep. It dosen't matter what way up you plant it.

Cover with cling film (saran wrap) or a clear plastic food bag and keep at about 75 Degrees F.

Seed will take about 5-10 days to pop.

When the seedling is about 2" tall, re-pot into compost/vermiculite/perlite (1:1:1) mix and put in a sunny spot. (Try and avoid direct sun until the plant is established)

Germinating mimosa hostilis seeds

With a little practice and fresh seeds you should be able to get a 99% success rate!

Gently make a nick or a scratch in the end of the seed. This is to help the seedling escape from its hard shelled seed-prison! We have a nice clean, sharp pair of nail scissors we use!

Boil a cup of water and allow it to cool for 10 minutes. Just enough to be able to dip your finger in.

It should still be very hot tho. Put the seeds in the water, they should sink. If they float, try making the nick on your seeds a little deeper. (not too deep though as this could harm the seed germ.) Leave them in to soak in the hot water for about 45 minutes. You will notice that they have swelled up slightly.

Place the swollen seeds in a pot of damp vermiculite (we use plant pods because they are so easy and germination friendly). Just place the seeds on top of the vermiculite, they need light to germinate. Lightly mist and cover with cling film or put the plant pod lid on.

Within two weeks the seeds will have started to germinate, but they are too small just yet, to replant. Instead, leave them in their vermiculite until they have pushed out their first set of leaves.

After another week, or when the first set of leaves have opened, the seedlings can be re-potted into a mix of compost, perlite and vermiculite (1:1:1) and placed in a propagator in a warm place (about 70 degrees F) and exposed to light, but not direct sun. (This can damage the seedlings at this size)

PSYCHOTRIA LEAF CUTTINGS

Here is a super-simple guide to making clones of any psychotria leaf.

This works with psychotria alba, viridis and carthagenensis.

It may well work with others, I haven't tried it.

Snap the leaf's spine 4 or 5 times

Wrap the snapped leaf in damp kitchen paper

Put the damp paper/leaf combo in a ziploc baggie

Leave in a warm place & open every few days to allow for fresh air exchange.

That really is it. In the picture above you can see I'v done just that with a psychotria alba leaf.

Roots have begun to form at the snapped points.

Simply break the leaves up at the rooted cuts and pot into an humidity dome or similar.

Each leaf section can produce upto 8 new plants!

UPDATE 30/12/15

Here are some more psychotria pics. These are Alba, viridis and the psychotria hybrid 'nexus'

They have all been grown using this TEK...

Try it and see what you think!

Have fun :)

STARTING ALL OVER AGAIN

Hello again my friends!!

 

Its been quite a while since i had time to blog anything, so I figured I'd give you all an update on what is happening in the wonderful world of Sampedros.com 

As you may remember we moved (my familly, plants, dog & I) to Spain. Although it was great and we all miss Valencia loads, due to unforseen family complications we had to return.

But enough of that.

Since I sold the-mush-room.co.uk last year I have had THOUSANDS of enquiries asking for Salvia divinorum, both active and edible spores, exotic, rare and interesting seeds and plants alike; So I have decided to re-open the now defunct mush-room again, under the umbrella of Sam Pedro's Ethno Emporium!

We have a new logo (well V2.0) to go with our new direction...

which I'm sure you will agree looks fine and funky! If you want some stickers please email me and I'll get some out to you!

So what is new about Sam Pedro'?

Funny you should ask. Over the coming weeks we will be building up our stock of non-cactus seeds and live plants, including two strains of Salvia Divinorum, Kratom & various shamanic and ornamental herbs and seeds. Since we have been collecting these since the mid 90's, we have more than a little experience and will be able to help you achieve the incredible garden you deserve.

We will be sending out a monthly newsletter too, so if you wish to receive one, please sign up for it on the home page of our site .

This blog will also get regular updates AND there will be our own You Tube channel where there will be instructions and teks and plant videos 

Finally may I wish all our valued customers and friends much love and happiness in their gardening efforts.

All the best

Sam.